Construction Machinery News - 黑料福利网

07/Jun2026

HAZ Cracking in Induction-Hardened Mast Channels

Turret trucks operating in deep-reach warehouses are suffering catastrophic structural failures. The mast I-beam channels are snapping laterally under load. The root cause is a severe lack of metallur

07/Jun2026

3C Fast Charging and the SEI Layer Decomposition of LFP Cells

To eliminate downtime, electric excavator OEMs are pushing "megawatt charging," demanding 3C fast charging rates (charging a 200 kWh battery pack from 20% to 80% in 20 minutes). While LFP (Lithium Iro

07/Jun2026

J1939 CAN Bus Overload and the 70% Arbitration Threshold

The modern excavator is a rolling data center. OEMs are integrating 360-degree cameras, grade control, and telematics onto the same J1939 Controller Area Network (CAN) bus that manages the engine and

06/Jun2026

Thermal Derating of AC Asynchronous Traction Motors

The shift to 80V AC asynchronous (induction) traction motors has eliminated brush wear, but introduced a severe thermodynamic limitation: continuous torque derating at high duty cycles. An AC motor's

06/Jun2026

ICP Spectroanalysis and the 15 PPM Death Threshold

Fleet managers are relying on oil analysis to extend drain intervals from 250 hours to 500 hours, but they are misinterpreting the data and destroying engines. Standard oil analysis uses Inductively C

06/Jun2026

The 0.3-Second Destruction of Power-Shift Clutch Packs

Wheel loaders operating in V-cycle loading face a hidden mechanical assassin: the power-shift transmission's shift overlap. To maintain momentum, operators often snap the selector from F3 directly to

05/Jun2026

Arc-Erosion in High-Amp Opportunity Charging Connectors

The push for multi-shift operations using "opportunity charging" demands massive current flows. Fast chargers push 300 to 500 amps into a lead-acid or lithium battery during a 15-minute break. The wea

05/Jun2026

CCV Filters and the Rear Main Seal Explosion

Tier 4 engines run with closed crankcase ventilation (CCV) systems. Instead of venting blow-by gases into the atmosphere, the gases are routed through an oil separator (crankcase filter) and back into

05/Jun2026

“De-Contented” Iron and the Return of the Dumb Machine

The global semiconductor shortage hit the heavy equipment industry hard, but the aftermath is reshaping the machines on the job site in a disturbing way. OEMs, unable to source the thousands of microc

04/Jun2026

“Opportunity Charging” and the Lead-Acid Thermal Trap

Warehouses are desperate to keep trucks running 24/7. The industry pushed "opportunity charging"-plugging a lead-acid forklift into a fast charger during operator breaks and shift changes instead of d

04/Jun2026

Coolant Cavitation and the Liner Pinhole Nightmare

Tier 4 Final engines produce massive peak cylinder pressures to burn clean and meet emissions. This extreme combustion force is causing a violent, hidden failure mode inside the engine block: coolant

04/Jun2026

The Cryptographic Lockout and the End of the Wrench

For the last decade, the "Right to Repair" war has been fought over access to service software. But OEMs are quietly moving far beyond software locks. They are introducing cryptographic hardware pairi

First 16 17 18 19 20 21 22 Last 19/32