Hello, I am a friend from Zhejiang, college graduate more confused, my dad let me go to learn the machine, follow the master of relatives, open a Carter 320C, now just learned 3 months, the wrong 6 things, good depressed ah!
First one: February 22nd began to contact and learn to excavate, 25 morning to stop the master of last night at the site of the site of a excavator to open a rotating railing board was hit and concave.
Second: there is a soil pool on the site. It rains a lot in the spring. I take the dug bucket and scoop out the water in the pool. When the water is inverted, the bucket opens and it hits the rail. It is concave.
Third: in the early March, the old dump truck on the site came to the ground in the pool, and I did not know what the day was.
Fourth: in April, 2 construction sites were separated by a road. I needed to open the excavator to another site. Because it was night, I also opened a rabbit block, in a turning place with a large iron plate, so that there are 2 pieces of the caterpillar have broken half, this is hard.
Fifth: in early May, I was playing butter and pulling the earth truck. I went straight to the cab and operated the excavator. Well, I always feel a little wrong. I looked down and threw a grease gun on the caterpillar. Now how to make a piece of iron, alas ~ ~
Sixth:
It happened today. When I was loading the car, I wanted to clean up the soil on the side of the tyres, and I was always careful not to touch the tyres. The end of the tail did not look at the head, the small arm bumps into the car railing, I touch the oil pipe on my arm, that link of the 4 screws, as if broken 2, hydraulic oil directly to the outside, the air is full of oil taste, I am afraid of death.
Every time I make a mistake, I feel scared. I'm afraid that I feel a bit useless. I call myself self blame.
