1 brake malfunction, I believe a lot of a friend opened the loader operation when the brake pause, brake high temperature failure, parts aging, too much wear, lead to the brake oil leakage and so on, I have a deep feeling, in the first time because of lack of experience, when the work finished, the boss called demand. The car opened back to the camp, because the road is far away, and the downhill road is much, in a corner, when the brake is on the brake when the key moment card shell, instinct response to step on a few more or not, the heart is clutches the direction, hit the roadside of the earth wall, fixed the car to see, the reason is frequent use of brakes, the reason. Causes the brake temperature to be excessively high, the brake oil spills, causes this accident the occurrence, afterwards calls the teacher to inquire carefully only then avoided this question. Summing up, in the long journey or down the downhill road with more than the use of engine speed, pressure enough to match the stop type point brake, so that the brake is not easy to high temperature, the pressure is also sufficient, repeated test, the sudden situation can also use the other gear mode. But that's the best way to do it.
2 hoisting, also, a lot of driver loaders also act as the role of the crane, even long distance transport. When we hoist the huge equipment, because of the high arm hoisting, the hoisting rope shakes and shakes the line of sight, which leads to the blind area of sight, can't see the road ahead, let alone through the narrow area. Even if there is a commander, he does not understand the situation of your driving, it will inevitably lead to a failure of command, the driver can not make the correct response in time, causing unnecessary accidents. In conclusion, the driver should shorten the hoisting distance by shortening the rope and hanging more bucket teeth to keep the safe distance from the ground when hoisting the equipment.
Also can reduce the arm, to reduce the center of gravity to keep the overall car stable state, to reduce the blind area of sight, when necessary, the reverse thinking, reversing driving, let the commander in their eyes range, to improve the safe driving.
3 high pile driving, I believe there are many North drivers, often in the stone factory, open mountain road in the situation will meet a headache, since the mountain road, the road planning is mostly attached to the mountain, hovering, stone, easy to collapse, easy to dump, it is difficult to push off the work, at this time it will be repaired. The way a simple road loader goes up and down from the top to the bottom is required to be repaired. When it comes to the stone that can't be shoveled, there will be a tail and tail fling and so on. In the case of a large vehicle circling the edge of the cliff, it is not allowed to happen. It is said that the mountain is easy to go down. Summing up, remove the vehicle condition, performance, three oil and one water, repair the slope of the wall of the inner road when the side plate is reduced, not to add the throttle, prevent the tyre from skidding, and not to strike the direction. When the obstacle is difficult to remove, it can be lowered to the ground by the big arm, the bucket is slightly warped and the state of the bucket is slightly warped. Center of gravity, let the bucket form an angle with the ground to slowly collect the bucket to complete the clear operation.
4 wading, when encountered in the sand field, when cleaning the river, it is unavoidable to meet the need for engineering vehicles to wade with water. When the vehicle wading, what is the depth of the wading and what should be paid attention to when wading water? What kind of land is safe to drive, this is a problem, such as a real car, the car can not stay in the original long time in the river, large lifting equipment can not reach, but then really wash the neck, waiting for the position of the knife to let the human flesh pain. To sum up, when we wade, we should first check whether the river bed or the sand bed and the silt bed. The river bed is usually the rock of the river, the dug can not be excavated, but the silt bed and the sand bed are the most headaches, and the weight of the carrying vehicles, the water point and the shore point should have a plan. To prevent the slash and shelved, as for the depth of the water, the individual suggestion that the engine fan leaves should not be submerged as much as possible, some of the loaders are made of plastic material, and the submergence can easily deform the deformation, even to sweep the water tank that is not worth the loss.
5 safe parking, a lot of people think that a common parking may have nothing, the loader is to put the fighter on the ground to stop, but in a special environment, it is not allowed to do so, before I and my colleague a piece of work, I opened the 953, he opened the Xiamen pioneer, work midway by the captain When I was in the front side, we stopped the car in front of the big car. When I stopped, I stopped in the front of the big car. When I stopped, I had a hand brake on the car, but I was stuck in the ground with a shovel. The next car was just like ordinary parking, and asked him to pull a hand brake, but the voice just fell, The trailblazers slipped and stopped until the top was on the counterweight of my car to avoid the accident. To sum up, when parking, we should observe the surrounding environment, especially in excavating the soil, digging the reduced operating environment of the mountain. It is necessary to pull the bucket on the ground when the slope is stopped, or to place the 90 degree of the car on the slope in the middle. When working on the road, it is possible to pull over the right car and reserve the width of the passing vehicles.
