Construction machinery repairing and maintenance knowledge for brand equipments Factory China - New - Liteng Machinery

17/Jun2021

The Structure Principle Of The Pilot Relief Valve Of The Pilot Hydraulic Syst...

The pilot relief valve of the Kato excavator is installed in the pilot gear, and the pilot gear pump is connected in series with the two main pumps. The hydraulic system continuously generates pres...

17/Jun2021

Kato Excavator Swing Motor Relief Valve

Two left and right swing relief valves are installed in the swing motor. 1. Pressure measurement method (1) Turn the start switch from the "ON" position to the "START" position,...

17/Jun2021

Check The Status Of The Kato Excavator APC100 System

Check the status of the Kato excavator APCI00 system. Before opening the APC100 system, you must make sure that the accelerator brake has been installed correctly. Otherwise, the engine speed is in...

17/Jun2021

Installation And Adjustment Of Accelerator Brake Of Kato Excavator

(1) Precautions when installing the accelerator brake ①The winding direction of the accelerator cable on the pulley should be changed according to the machine type, because there are two prescribed...

17/Jun2021

Kato Excavator Inspection And Replacement Of Engine Oil

Check procedure If the oil level gauge shows that the oil level is lower than the normal oil level, the oil should be full. Note that the oil filling should not exceed the "FULL" position...

17/Jun2021

The Principle Of Kato Excavator Bucket Circuit

The bucket cylinder of the Kato excavator is controlled by the valve core 3 of the control valve (valve block B). When the bucket spool is in neutral, the bucket cylinder stops. By moving the bucke...

17/Jun2021

How To Save Fuel When The Loader Is Working

Loaders are large-scale mechanical equipment and consume a lot of fuel. Therefore, you must pay attention to operating skills in daily work to effectively save fuel. What are we doing Reasonable se...

07/Jun2021

Kato Excavator Arm Circuit Breakdown

The forearm cylinder of the Kato excavator is controlled by the spool 4 of the control valve (valve block A) and the spool 5 of the control valve (valve block B). When the forearm spool is in neutr...

07/Jun2021

Principle Of Kato Excavator Boom Circuit

The two cylinders of the boom of the Kato excavator are controlled by the spool 4 of the control valve (valve block B) and the spool 3 of the control valve (valve block A). When the spool of the bo...

07/Jun2021

Graphic Explanation Of Removal And Installation Of Multiple Control Valves Fo...

1. Preparation for demolition Bleed the compressed air in the hydraulic oil tank. 2. Demolition (1) Put a label on the hose in the remote control pipe between the multi-way control valve and the ma...

First 157 158 159 160 161 162 163 Last160/359

黑料福利网

Knowledge

The Structure Principle Of The Pilot Relief Valve Of The Pilot Hydraulic Syst...

Kato Excavator Swing Motor Relief Valve

Check The Status Of The Kato Excavator APC100 System

Installation And Adjustment Of Accelerator Brake Of Kato Excavator

Kato Excavator Inspection And Replacement Of Engine Oil

The Principle Of Kato Excavator Bucket Circuit

How To Save Fuel When The Loader Is Working

Kato Excavator Arm Circuit Breakdown

Principle Of Kato Excavator Boom Circuit

Graphic Explanation Of Removal And Installation Of Multiple Control Valves Fo...