Similar to excavators, construction machinery can not be separated from trucks as a good partner. Excavators are usually transported by flatbed trucks. There are exceptions, of course. Small excavators sometimes use light trucks.
Do you know how many steps it takes for a light truck on the excavator? Today we will see a foreign excavator driver how to do it. A small crawler excavator ready to get on, the driver used the usual direct way to get on, foreign drivers are so direct!
In the first step, the driver controls the excavator to move forward and the track on the side of the bulldozer is off the ground, and the bucket is mounted on the bucket.
The second step, the shovel of the excavator plays a supporting role in the rear of the excavator. The excavator is supported on the inner of the bucket, and the excavator is supported as a whole. At this time the excavator's walking device and the rotary platform are suspended.
Thirdly, the distance between the excavator and the car keeps drawing closer, and the track forms an angle with the ground until the front of the track is pressed against the rear of the car.
The fourth step is not to support the bucket inside the bucket, the rotary platform rotates 180 degrees until the top of the bucket is on the ground.
The fifth step, the excavator has turned over, the bucket and ground contact, start the excavator started to get on the car, at this time is in a horizontal position.
The sixth step is to start reversing until the walking device enters the carriage as a whole.
The seventh step, of course, is to roll up the boom and put the excavator's working device in the right place.
After seeing the operation of the driver of the foreign excavator, did he recall the things he was digging up? Is it possible to get on the car like this? Welcome to share your experience and story of excavators.
