Experience is usual to pay attention to careful observation and slowly groping accumulated, the master is also step by step, each person has their own small tricks or small methods, in order to operate the normal machine, who all mind the thinking way, including me, how to lower the failure rate, prevention, problems at any time Deal with minor problems in time so as not to pull out big problems.
In the bucket axis this, I met in the actual work of other machinery to care about little, the reason, even if bad, change the new also can not spend much money, a word, lazy, dirty, do not want to deal with it, two thousand hours to three thousand hours to change the shaft, the inner sleeve of the big people in, how unpleasant to open up during the period. Suit. I met more in reality, very common, the boss said that the boss said, are all hasty, inside the mill, the shaft grinding, when working, the dug bucket and the small monk shaking the head, shaking, rubbing and colliding a variety of harsh sound, listening to the difficult, work to watch the heart, wobbly, wrenching.
Three points machine, seven points maintenance, mechanical energy normal operation all rely on maintenance, so maintenance machine is work can not fail, good maintenance of their own comfortable, and also avoid a number of failures.
The dustproof ring of the bucket axis can be made at the site, zero cost, the need to have tools, the site everywhere can find materials, local materials, can be met at the site at ordinary times, just can use the waste, kill two birds with one stone.
I use this flour bag as a dustproof ring for a long time, and durable, anti sand effect is obvious, lash up simple, bushing butter will not be worn by sand, butter is easy, no butter eye, occasionally one or two times no butter, no harm, more or less harmless, I am or play a role, I am, I am Deeply understand, practical, good results, it is worth recommending.
Equipment appearance: today's owner
Model: Liugong 925D
Working hours: five thousand and five hundred +
Construction site: Wuwei, Gansu
Construction conditions: sand and gravel. Earthwork
The bucket axis, so far, the inner sleeve has been replaced.
Step 1
Preparation materials: gloves, ash knives, vise, 27 open spanner two, bucket shaft gasket, iron wire, flour bag.
Iron wire and flour bag are found at the construction site, no cost. I'll put some effort to tie up them.
Step two
First, the old dustproof ring is removed, then the prepared grey knife will be used to clean up the accumulated waste butter and dirty things at the junction of the bucket. The cleaning purpose is better tied to the wire.
Step three
Both sides clean clean, you can see the gap in the bucket is very small, this is the effect of dust ring, dust ring work can not be done, originally prepared to dismantle the bucket with a gasket, before adding a cushion, the gap is too small and good gray knife can go down, too tight, temporarily added, and so after, in addition, white prepared a game?
Step four
After cleaning up, we begin to make it. Fold the flour bag to just be able to put it down. The width can be broken to the left and right. After folding it, the pressure will run back to the original, and the pressure will be better.
Step five
Before loading the ready old tiger forcep, first cut the wire, cut the length out of a few centimeters, cut short can be scrapped, so it can be long, when loading the strength of the flour bag tight, the more tight the better, the direction of the bag must be to the bucket oil cylinder.
The reason: if the bag is reversed, the time will be long, and the dust will be drilled into it, affecting the practical effect. So pay attention to the direction of the pocket.
The first wire is tied up first, when the wire is tied, the wire must be tightened, the wire must be tightened, the wire is loose, the flour bag inside will loose, and the loose will not work. The key is that the first wire must be tightened, and the success or failure is the success or failure.
Step six
Second wire binding on the other side, the middle first left, the operation is the same, wire tightened, pay attention to the screwing down the wire head down, a little attention to avoid being scratched by the wire head.
Step seven
Finally, the middle of the kidnapping, the same operation, the emphasis should be tightened, tied after the effect can be counted, the whole process can not be spent long, the use of the effect that is good.
Step eight
The last step, this is what I did before, in order to avoid too big stone squeezing and crushing the dustproof ring to reduce the use time, the site is made of material, waste utilization, the whole cost of the whole.
Summary:
Whether it can not play a role, try to know, it is no more than take the rest time, after success only benefits, no harm, failure is the mother of success, the treatment of any thing, no matter the size, as long as you do it seriously, certainly will effect. Believe in yourself, come on.
