After the electric loader leaves the factory, it generally needs a running in period of 60 hours, which is also required according to the new technical characteristics of the installation and early application of the cutting machine. The running in period is to ensure the normal operation of the cutting machine and reduce the equipment failure rate Key steps to increase its service life. Some consumers lack the basic knowledge of installation and layoff, or due to the rush hour Or they want to make quick profits and despise the special technical standards during the running in period of new mobile phones. Some customers even think that, in short, the manufacturer has a warranty period, and the damage of the machine is maintained by the manufacturer. Therefore, the machine is overloaded for a long time during the running in period. The early common failures of the machine caused by the wheel loader often occur, which not only endangers the normal application of the machine, but also reduces the service life of the machine and endangers the construction progress due to the damage of the machine.
?? 1) before safe driving and work, the staff operating the wood loader shall be familiar with various characteristics, structure, technical maintenance and operation mode of the cutter and operate according to the regulations.
? ? 2) except for the driver's cab, no passengers are allowed in other areas of the unit.
? ? 3) when pouring the bucket into the vehicle, lift the bucket to the relative height where it is not easy to contact the compartment baffle, resolutely prevent the bucket from hitting the vehicle, and it is strictly prohibited to turn the bucket over from the Toyota Corolla roof.
? ? 4) select full-automatic deceleration when going downhill. Do not step on the clutch pedal to prevent the safety accident of the pulley after disconnection.
?? 5) the machine shall be shut down immediately after going out for inspection. If it is found that the brake system fails due to soaking, the continuous brake system shall be carried out, and the moisture in the brake pad shall be removed by scalding to quickly recover the brake system.
? ? 6) when the loading and cutting machine is working, no one can stand in front of it. During the whole driving process, the bucket cannot carry passengers.
?? 7) during operation, it is strictly prohibited to stand under the shovel arm, and irrelevant workers and other mechanical equipment are strictly prohibited to work and drive here.
?? 8) it is forbidden to select the fast gear for work.
?? 9) when the operator leaves the driving part, the bucket must be on the ground, the engine must be turned off, and the switching power supply must be disconnected.
